Country of Origin: Made in USA. Cost: $15.07 per roll. 12 Rolls to a case. For Markem Near Edge Printers Toughest Resin Ribbon In the Market.
The Wicked Tough Resin Ribbon Extreme Solvent Resistance. View Our Wicked Tough Resin vs The Chemicals. Yes. We are that good. Extreme Abrasion Resistance. Test our Ribbon Against Your Tough Environment. Free Ribbon Sample. Extreme Abrasion Resistance for High Heat Applications. Works Very Well with Kapton Labels. Extreme Abrasion Resistance for Automotive, Circuit Board and Wave Soldering Label Applications.
Our Wicked Tough Resin Formula Transfers a Conditioning Layer to the Label Prior to Ink Transfer. This Layer Conditions Your Label to Increase Ink Absorption. You are now Producing Labels with Extreme Abrasion Resistance.
This Wicked Tough Near Edge Resin Ribbon is Coated Side In (a.k.a ink on the inside). Inner diameter (core size) of this ribbon is 1” (25.4mm). These ribbons can reach print speeds of up to 26 IPS (inches per second) and have an ink transfer temperature of 81°C (178°F).
LabelStock (a.k.a Substrate): Kapton Labels, Vinyl (Topcoat), Polyesters (Gloss Topcoat), Polyesters (Matte Topcoat), Polypropylene, Polymide, PET cards, Polyonics, PVC Cards< Nylon and many others.
We are so Confident in This Ribbon Formula, We will Provide aFree Ribbon Sample. Test Your Label Stock and Printer. Remove all Doubts. Call Us at: 1-800-434-9011
Our Wicked Tough Near Edge Resin ribbon is also known by the following Part Numbers: 18107124
Ribbon width should be 1/4 to 1/2 inch wider than the label or label carrier (backing of label). If you go too wide on the ribbon, you run the risk of causing the ribbon to wrinkle. If you go to narrow you will experience a reduced lifespan of the printhead.
The duller side of the ribbon is the ink coated side. This ribbon’s ink is on the inner side of the ribbon. The shiny side is on the outside and duller side faces in.
Our ribbon’s backcoating is formulated for printhead protection. The backcoating creates a protective barrier that results in significantly less build-up on your printhead’s heating element.
Our ribbon’s ink formulation dissipates static, preventing static build-up and reducing the threat of printing voids or the potential for a spark burning out a printhead.
Our Premium Near Edge Resin ribbon is approved by the following Agencies: FDA (indirect food contact), REACH & RoHS
Our ribbons are ISO 9001 Quality Management and ISO 14001 Environmental Management certified
Our Premium Near Edge Resin ribbons are Halogen Free.
Our ribbon’s recommended shelf life is one year. Avoid high humidity and direct sunlight during storage. Storage temperature should be 41°F to 95°F (5°C to 35°C) at 20% to 85% Relative humidity.
Our Premium Resin Near Edge Resin Formulation is also known by the following Names: R396, AXR 600, Net Resin IQ, UH710, US550, US710
If you do not see your printer model on the list below we still have a ribbon for you. Contact us so we can match you with the correct ribbon 1-800-434-9011. These Premium Resin Near Edge Ribbons Work in the following Printer Models: