Resin Ribbon: 4.17” x 1,968’ (106.0mm x 600m), Ink on Outside, General Use, Near Edge, $35.50 per Roll in 24 Roll Case

Current Stock:
1 (800) 434-9011
in stock

Country of Origin: Made in USA. 
Cost: $35.50 per roll. 24 Rolls to a case.
For Toshiba Tec Near Edge Printers
Printhead: Protective Backcoating & Anti-static.

LabelStock (a.k.a Substrate):
Polyester, Polyethylene, Polyolefin, Polypropylene, Synthetic Paper, PVC Card, Vinyl, Kimdura®, Polyart®, Valeron®

These General Use Near Edge Resin ribbons are coated side Out (a.k.a ink on the outside). Inner diameter (core size) of this ribbon is 1” (25.4mm).These ribbons can reach print speeds of up to 6 IPS (inches per second) and have an ink transfer temperature of 86°C (187°F).

Questions Call Us at: 1-800-434-9011 
Click here for a free sample request

Our General Use Near Edge Resin ribbon is also known by the following Part Numbers: 18105514

  • Ribbon width should be 1/4 to 1/2 inch wider than the label or label carrier (backing of label). If you go too wide on the ribbon, you run the risk of causing the ribbon to wrinkle. If you go to narrow you will experience a reduced lifespan of the printhead.
  • The duller side of the ribbon is the ink coated side. This ribbon’s ink is on the outer side of the ribbon. The shiny side is on the inside and duller side faces out.
  • Our ribbon’s backcoating is formulated for printhead protection. The backcoating creates a protective barrier that results in significantly less build-up on your printhead’s heating element.
  • Our ribbon’s ink formulation dissipates static, preventing static build-up and reducing the threat of printing voids or the potential for a spark burning out a printhead.
  • Our General Use Near Edge Resin ribbon is approved by the following Agencies: FDA (indirect food contact), REACH & RoHS
  • Our ribbons are ISO 9001 Quality Management and ISO 14001 Environmental Management certified
  • Our ribbon’s recommended shelf life is one year. Avoid high humidity and direct sunlight during storage. Storage temperature should be 41°F to 95°F (5°C to 35°C) at 20% to 85% Relative humidity.

Our General Use Resin Near Edge Resin Formulation is also known by the following Names: AS1, RS1, SS1, R390, AXR800, AXR 900, HT13, HT17, P310, B120EC, US780

If you do not see your printer model on the list below we still have a ribbon for you. Contact us so we can match you with the correct ribbon 1-800-434-9011. These General Use Resin Near Edge Ribbons Work in the following Printer Models:

Toshiba Tec: B-372, B-470, B-472, B-482, B-572, B-SX4, B-SX4T Series, B-SX5, B-SX5T Series