Country of Origin: Made in USA. Cost: $7.08 per roll. 48 Rolls to a case. Best In Class for Abrasion and Solvent Resistance.
Our Heat Shield Resin provides Best in Class Heat Resistance: Up to 390 degrees Fahrenheit which is 100 degrees higher than Zebra’s 5095. This ribbon rocks if your package goes through a heat tunnel or undergoes heat sterilization.
These Resin ribbons are coated side in (a.k.a ink on the inside). Inner diameter (core size) of this ribbon is 1” (25.4mm). These ribbons can reach print speeds of up to 8 IPS (inches per second) and have an ink transfer temperature of 199°C (390°F).
We are so Confident in This Ribbon Formula, We will Provide aFree Ribbon Sample. Test Your Label Stock and Printer. Remove all Doubts. Call Us at: 1-800-434-9011
Part Number Compatibility: 18100922, FST03830 & SAT310-040410
Ribbon width should be 1/4 to 1/2 inch wider than the label or label carrier (backing of label). If you go too wide on the ribbon, you run the risk of causing the ribbon to wrinkle. If you go to narrow you will experience a reduced lifespan of the printhead.
The duller side of the ribbon is the ink coated side. This ribbon’s ink is on the inner side of the ribbon. The shiny side is on the outside and duller side faces in.
Our ribbon’s backcoating is formulated for printhead protection. The backcoating creates a protective barrier that results in significantly less build-up on your printhead’s heating element.
Our ribbon’s ink formulation dissipates static, preventing static build-up and reducing the threat of printing voids or the potential for a spark burning out a printhead.
Our Heat Shield Resin ribbon is approved by the following Agencies: FDA (indirect food contact), UL, REACH & RoHS
Our ribbons are ISO 9001 Quality Management and ISO 14001 Environmental Management certified
Our ribbon’s recommended shelf life is one year. Avoid high humidity and direct sunlight during storage. Storage temperature should be 41°F to 95°F (5°C to 35°C) at 20% to 85% Relative humidity.